Kvaser PCcan

The PCcan product family comprises three members: PCcan 4xHS, PCcan HS/HS, and PCcan HS

Hardware

• The board is a quarter-size (length 135 mm) 8-bit ISA bus board and occupies 64 bytes of I/O space. The base address can be any of 200H, 240H, 300H, and 340H. The interrupt signal on the CAN controllers can be connected – under software control – to any one of IRQ 2/9, IRQ 3, and IRQ 5 on the ISA bus.
• The original 16 MHz oscillator may be replaced with an oscillator of frequency range 1–24 MHz to obtain the required bit rate on the bus. The PCcan 4xHS board draws approximately 600 mA at 5V.
• The industry-standard CAN controllers on the PCcan cards are directly accessible to the programmer. This makes the cards suitable for cross-platform development: you can develop your software on your PC and then move it, with a minimum of changes, to your embedded system.
• The CAN controllers support CAN 2.0 A and 2.0 B (active.) The CAN bus drivers supports the standard, high-speed ISO11898 physical layer.

External Connector

• The outputs from the CAN circuits are connected to female D-SUB connectors via optocouplers and bus drivers (Philips 82C251, conforming to ISO 11898).
• The connectors provide the voltage feed for the bus section (optocouplers and driver circuits). Alternatively the PC is used as power source; however this gives no galvanic separation between the computer and the CAN bus.
• On the PCcan 4xHS card, it is possible to connect all the 4 CAN in/outputs to a common CAN bus, which is also connected to the CAN-connector.

Software

The following software is available for the Kvaser PCcan family:

• Driver routines: libraries for DOS; 16-bit DLL for Windows 3.1; 32-bit support for Windows 95/98/ME/2000/XP/2003/Vista/7 and NT 4.0
• CanKing for Windows, a general-purpose interactive CAN bus monitor/analyzer.
• Kvaser CANLIB SDK, which includes everything you need to develop software for the Kvaser CAN boards. Includes full documentation and many program samples, written in C, C++, Delphi, Visual Basic, and C#. All Kvaser CAN interface boards share a common software API. Programs written for one board type will run without modifications on the other board types!
• J2534 Application Programming Interface
• RP1210A Application Programming Interface
• Documentation, software and drivers can be downloaded for free from www.kvaser.com, or they can be purchased on CD if preferred. Updates of the software are regularly posted on the web.
• All our CAN interfaces share a common 32-bit API. You can use the same programs, without modifications, for all our CAN interfaces! 

Product versions

• Kvaser PCcan 4xHS (Item No. 00049-0)
  Four CAN channel interface for the ISA bus with 2 x SJA1000 and 2 x 82527 CAN controllers. Built-in loopback and terminator. One 25-pin D-SUB connector.
• Kvaser PCcan HS/HS (Item No. 00051-3)
  Two CAN channel interface for the ISA bus with 2 x SJA1000 CAN controllers. Two 9-pin D-SUB connectors.
• Kvaser PCcan HS (Item No. 00050-6)
  One CAN channel interface for the ISA bus with 1 x SJA1000 CAN controller. One 9-pin D-SUB connector.

<< Back to Products Index